Finally, A Reusable Drain Board Insert for Concrete

So we've made a number of drainboard inserts, but never had a design we really liked enough to go to all the trouble of making it into a mold. Until now that is:


In less than two minutes, this fiberglass mold can be added into any countertop mold to make a sloped drainboard. Grooves for 'additional' drainage (you can never have enough drainage) and nice aesthetics. Are you saying goodbye to the drainboard-making headaches yet??

Will be available for shipping 2nd week in July, along with a few of the new sink molds we've designed. Order now, so we can get it shipped as soon as we get them finished!

Yin Yang Sink Now Pre-Ordering

We've released a few photos (one is displayed below) of the new Yin Yang (Ying-Yang) Sink Mold Design. The Mold will be ready to start shipping in about two weeks. Each mold is one half of the Yin Yang symbol, so when two of the molds are used side by side, allowing a space between them for concrete, they will create the Yin-Yang design into a concrete sink.

It's been designed as a 'larger' sink, meaning each of the sink sides can fit an 11.5 inch diameter dinner plate comfortably in the bottom of the sink. The Drain sizes are your typical kitchen size, so a garbage disposal can be attached.

The sink mold is also available singly, as the Tear Drop sink mold. Uses would be entertainment bars, outdoor sinks, washrooms, etc. Wait, it'd be your sink, so I suppose YOU get to decide its use, not us!

We'll start to publish photos of actual concrete work using the Yin Yang Sink Molds near the end of July. We're looking forward to some cool effects being created using different colors/stains for the two vessels. Pre-order here.

New Myspace Page

Anyone into the whole 'Myspace' thing, check out our site there: www.myspace.com/concretecountertops.

Ramp Mesa Sink

We are in the final stages of production for our new Mesa Ramp sink mold. Similar to the current Ramp mold we have, the Mesa Ramp has dozens of small layers that the water will cascade over on its way to the bottom slot-drain. The sides of the Mesa Ramp mold have also been increased to a 15 degree slope (the current Ramp mold has 5 degree side slope). The mold can be ordered today, and should start shipping the second week of July.